Articles with the tag: #troubleshooting
802.1X Switch port is amber when only IP Phone is connected
When 802.1X (wired) is configured on a 3750G switch, the port LED is amber when only an IP Phone is connected (mab). When connecting on the IP Phone a downstream device like a laptop (dot1x), the port LED goes to green.
Schneider-APCUPS battery replacement
Small how-to about Schneider-APC UPS battery replacement and setting replacement date in Network management card.
Cisco SSM On-Prem password recovery procedure
For a Cisco Smart Software Manager Test Drive installation I used the older version 8-202010 and I wanted to perform an upgrade to the latest version 8-202108. And of course it is a test drive, I did not save or wrote down the password :). In this document I'm describing how to perform a password recovery for a Cisco SSM On-Prem installation.
Troubleshooting SFP transceivers and Packet captures
In an older blog post I was writing about "Useful Cisco Commands for Troubleshooting cable problems". In this blog post I'm showing an additional, useful commands for Fiber Optics troubleshooting and packet capturing on Cisco switches.
Cisco WLC - No secured WebUI after failover switching
Cisco WLC 3504 secured WebUI is not working on Secondary Unit in a failover (SSO) setup. When switched back to the Primary Unit, the secured WebUI is working again. Troubleshooting and solution of this strange behavior.
Fritzbox rack mounted
Fritzbox rack mounted on a 19" shelf and it's hardware issues: white description on a white box, no LED on ports for activity, height unit issues, Square wood and Velcro to fix ;)
Fritzbox on redundant ASA Firewall
Setup of two redundant Cisco ASA firewalls on a Fritzbox cable modem with Non-routed transfer network to keep the "PC-MAC"/"exposed host" configuration on Fritzbox during ASA failover switching
Netbox Login failed after upgrade to version 2.9.0
After an upgrade to the new released version 2.9.0 of NetBox the Login failed with Server Error (Missing required package/WSGI service not restarted after upgrade)
Upgrading XCP-NG Hypervisor from version 7.6 to version 8.1
Upgrading XCP-NG Hypervisor from version 7.6 to 8.1 remotely over VPN connection and KVM. Fixing IPTables and SNMP configuration for monitoring system.
Useful Cisco Commands for Troubleshooting cable problems
Useful Cisco Commands for Troubleshooting problematic cabling (Cat.x and Fiber optics).